2010 Range Rover – Auto high beam

This function automatically selects high beam, if ambient light levels are sufficiently low and
no oncoming or preceding vehicles are within operational range.

Note: It is recommended not to use auto high beam whilst driving off-road.

This function is only active if the lamps master switch is in the  AUTO position and the stalk is in the central position. The system will only activate when the vehicle reaches 25 mph (40 km/h). The system will deactivate when the vehicle’s speed drops below 15 mph (24 km/h).

Note: Auto high beam does not operate when reverse gear is selected.

Auto high beam can only be considered as a convenience feature and in certain circumstances the driver will be required to intervene.  To manually over-ride the feAHBature to high beam, move the stalk to the high beam position as normal. To over-ride the feature to low beam (from high beam only) operate the stalk to the ‘flash’ position and the feature will be cancelled. To re-enable the feature operate the stalk to high beam and back to the central position.

An indicator in the instrument panel illuminates when auto high beam is enabled.
Note: The following circumstances could affect the auto high beam function:
– Highly reflective road signs.
– Vehicles with dim lamps. e.g. bicycles, etc.
– Adverse weather conditions.
– Dirty sensor.
– Dirty, damaged or misted windscreen.

It remains the driver’s responsibility to ensure correct use of the headlamps at all times.
To turn off the auto high beam feature, move the lamps master switch from the AUTO
position to the headlamps on position.

Note: The auto high beam feature is controlled by a sensor in the rear-view mirror.

Ensure that the sensor is not blocked by objects or stickers placed on the windscreen.

Comments are closed.